%0 Journal Article
%T Coexisting arsenate and arsenite adsorption from water using porous pellet adsorbent: Optimization by response surface methodology
%J Global Journal of Environmental Science and Management
%I ISWA-GJESM
%Z 2383-3572
%A Te, B.
%A Wichitsathian, B.
%A Yossapol, C.
%A Wonglertarak, W.
%D 2018
%\ 04/01/2018
%V 4
%N 2
%P 141-152
%! Coexisting arsenate and arsenite adsorption from water using porous pellet adsorbent: Optimization by response surface methodology
%K Analysis of variance
%K Arsenic removal
%K Central composite design
%K Mesoporous adsorbent
%K Response surface methodology
%R 10.22034/gjesm.2018.04.02.003
%X Mesoporous pellet adsorbent developed from mixing at an appropriate ratio of natural clay, iron oxide, iron powder, and rice bran was used to investigate the optimization process of batch adsorption parameters for treating aqueous solution coexisting with arsenate and arsenite. Central composite design under response surface methodology was applied for optimizing and observing both individual and interactive effects of four main influential adsorption factors such as contact time (24-72 h), initial solution pH (3-11), adsorbent dosage (0-20 g/L) and initial adsorbate concentration (0.25-4.25 mg/L). Analysis of variance suggested that experimental data were better fitted by the quadratic model with the values of regression coefficient and adjusted regression coefficient higher than 95%. The model accuracy was supported by the correlation plot of actual and predicted adsorption efficiency data and the residual plots. The Pareto analysis suggested that initial solution pH, initial adsorbate concentration, and adsorbent dosage had greater cumulative effects on the removal system by contributing the percentage effect of 47.69%, 37.07% and 14.26%, respectively. The optimum values of contact time, initial solution pH, adsorbent dosage and initial adsorbate concentration were 52 h, 7, 10 g/L and 0.5 mg/L, respectively. The adsorption efficiency of coexisting arsenate and arsenite solution onto the new developed adsorbent was over 99% under the optimized experimental condition.
%U http://www.gjesm.net/article_29749_d31e630783b8d09edba71d127375b45e.pdf